Cisco AP Detailed Client Info
Trying to figure out what some of these mean… You can use show dot11 assoc
to find clients associated to the AP then you can use show dot11 assoc xxxx.xxxx.xxxx
to show detailed information for a specific client or even use ‘all-clients’ to show all clients detailed information that are associated to the Access Point. Here’s the output from show dot11 all-clients
Address : 0023.68b1.b06a Name : NONE
IP Address : 0.0.0.0 Interface : Dot11Radio 0
Device : unknown Software Version : NONE
CCX Version : NONE Client MFP : Off
State : Assoc Parent : self
SSID : WiFi
VLAN : 101
Hops to Infra : 1 Association Id : 28
Clients Associated: 0 Repeaters associated: 0
Tunnel Address : 0.0.0.0
Key Mgmt type : NONE Encryption : WEP
Current Rate : 48.0 Capability : WMM ShortHdr ShortSlot 11h
Supported Rates : 1.0 2.0 5.5 11.0 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0
Voice Rates : disabled Bandwidth : 20 MHz
Signal Strength : -75 dBm Connected for : 299 seconds
Signal to Noise : 21 dB Activity Timeout : 16 seconds
Power-save : On Last Activity : 44 seconds ago
Apsd DE AC(s) : NONE
Packets Input : 225 Packets Output : 68
Bytes Input : 11342 Bytes Output : 5154
Duplicates Rcvd : 34 Data Retries : 45
Decrypt Failed : 0 RTS Retries : 0
MIC Failed : 0 MIC Missing : 0
Packets Redirected: 0 Redirect Filtered: 0
I need to find out what “Capability : WMM ShortHdr ShortSlot 11h” means and available options. These clients are connecting at lower speeds when they do not have “WMM” in the Capability column.